These scripts load display lists within the model file, with certain aspects, properties, and checks applied. They are found at the end of a model file.

Runs one or both child geometry layouts, sorting based on positions. If vectors are u and v, run first child first if (v-u).u >= 0. Used to depth sort translucent geometry. Usage:

—-

Loads a display list from the DL segment and attaches it to the current group of bones with ID. Usage:

*Continue: If 00, GeoLayout stops after command. If 0x10, GeoLayout continues.

Loads a display list from offset of F3DEX segment Usage:

*Continue: If 00, GeoLayout stops after command. If 0x10, GeoLayout continues. Example: 00 00 00 03 00 00 00 00 00 2D 00 10

Addr= 0x2D*0x08 offset from F3DEX Segment Start, 0x168 0x10= 16 triangles in DL

Draw triangles across bones. Usage:

Runs a geometry layout if the distance from the camera is in a certain range.

Computes a point on the current model to be referenced later. Used for spawning sparkle particles and Clanker's teeth/bolt positions. Usage:

Selects one or more child geometry layouts to run. Used for blinking and many other model part selections, like Mumbo's hut. Each model sets a list of selectors, where positive values are the index of a (single) child layout to run and negative values (after being negated) are bitfields indicating multiple children to run. Usage:

Applies draw distance to descending geometry Usage: